High built Rubber heat transfer

1. Rubber heat transfer 2.3D hand feel 3.Thickness from 0.4mm to1.0mm 4.DTM color/ Metallic/ Foil/ Neon colors avaible

Special on High built Rubber heat transfer:

Color:	Any Color (DTM color/ Metallic/ Foil/ Neon colors)
Max. size:	200 x 200mm
Country of Origin	China
Features:	-3D hand feel-Thickness from 0.6mm to 1.0mm-DTM color/ Metallic/ Foil/ Neon colors are available -Environmental friendly
Testing or Certificates:	-Passed Washing and CHemical tests in US /EU standard

Application Conditions for high built Rubber heat Transfer:

Method:	Heat transfer
Transfer Temperature:	160°C
Transfer Time:	1st Press - 5 Sec, 2nd Press – 18 - 20 Sec
Transfer Pressure:	0.2 Mpa / 200gf/cm2 (Light)
Peeling Way:	Cool
Suggest Silicone Pad size	40cm x 50cm

**Please provide bulk fabric for us to test the accurate application**

Procedures for Raise Rubber heat Transfer:

1. Place the transfer on the correct position

2. 1st Press: Applied heat for 5 seconds on the face side then place a release paper on top to cover the whole garment from heat 

3. Reverse the garment (garment facing down)

4. 2nd Press: Apply heat for 18 – 20 seconds using light pressure

5. Let motif completely cool down before peeling off backing film

Recommended wash care symbol:

- Machine Wash, Cold (initial water temperature should not exceed 30C or 65 to 85F)

- Tumble Dry, Normal, Low Heat (A machine dryer may be regularly used at a maximum of Low Heat setting)

- Do not Iron

- Do not Bleach

- Do not Dryclean

High built Rubber heat transfer